#ECR WIRES ON SENSUS WATER METER INSTALL#
#ECR WIRES ON SENSUS WATER METER DRIVER#

Then in January, Ambrose's bill jumped to 448 HCF, totaling over $4,800. In her June-through-September bill last year, after LauraвЂ™s water meter was replaced with a new smart water meter, Laura saw her bill jump to more than $800. Laura said her family usually pays around $200 every two months for 35 to 40 hundred-cubic-feet (HCF) of water.

#ECR WIRES ON SENSUS WATER METER DRIVER#

It is the abbreviation for National Standard Free-Fitting Straight Mechanical Pipe Threads (NPSM).Man Hit and Killed by Car on Chollas Parkway, Driver Flees These water meters comply with low flow standards for California sub-metering, as well as current low lead legislation, making them an ideal choice for replacing your non-compliant water meter.ДЄ. If a meter is physically removed from service and it does not comply with the local regulations or standards, a compliant product must be installed. 'If I remove a meter from service for testing or repair, can I put it back into the system?'ДЄ. The only water meters that we offer are on this page. We do not offer any remote read water meters.

#ECR WIRES ON SENSUS WATER METER INSTALL#

'I am looking for a water meter that I can install outside but read inside my house. Running any other fluid through them is not recommended, would not produce an accurate reading and will void the warranty. These are great water meters but are only designed for cold, potable water. 'Can juices, vinegar, salt water, etc be run through these water meters?'ДЄ. However, for any new installation, a set of unions would be needed. Because most water meter brands have the same sized unions, many people buy these great meters from us as replacements for other brands and don't need new unions. 'If you have to use these water meters with unions, why do you even offer them separately?'ДЄ. You need unions to convert the threads on the SR II meters to IPS, and use hose fitting adapters from pipe fittings to hose size. 'Do I need unions to hook the SR II water meters to a garden hose?'ДЄ. The Omni R2 and the SR models require special meter flanges as those two models have flange ends. You must use water meter unions on the 5/8'-1' models (most other brands will fit as well) because the threads (as with most brands of water meters) are non-tapered and require a rubber or neoprene washer to seal the connection. 'Can I not use a union and install them with regular couplings or maybe use a soldered female adapter?'ДЄ. We don't know why anyone would prefer it that way but, we do sell/offer them. Many are still in existence in cubic foot measurements and some water companies still use the cubic foot measurement instead of in gallons. 'Why would anyone want these meters in cubic foot increments instead of gallon measurements?'ДЄ.

Compatible with Sensus, Neptune, Badger, Elster, and Hersey water meters.

Not for submersible or pit installations.

Multiple registers can be connected to this single SmartPoint.

Allows water utilities to effectively detect leaks in a water system.

Instantly transmits top of the hour readings and other diagnostic information to water utilities when used as fixed base end-point.

Can be used as a fixed base endpoint to interact with a Regional Network Interface (RNI) (requires a base station).

Collects data and waits for an activation signal from the Vehicle Gateway Base-station (drive-by) or Hand-Held Device (walk-by) to transmit readings, meter identification and any alarms.

TouchCoupler design enables connection to the water meter using existing AMR two-wire installations instead of installing a new three-wire system into a home, saving water utility installation costs.

Allows water meters to interface with the FlexNet В® communication network.

Remotely sends input information from the water meter register to a walk-by or drive-by collection device carried by water utility worker.

Radio transceiver gives water utilities access to water meter information through a radio signal.

The Sensus 510M FlexNet В® SmartPoint В® features: (two flanges needed per meter for new installations)Дў-Bolt Oval Flange - 2 FIPT - for 2' water meter в†“ Water Meter Unions and Flanges - sold individually в†“Дў-Bolt Oval Flange - 1-1/2' FIPT - for 1-1/2' water meter View Omni R2 dimensions and specifications

ADA Compliant & Independent Living AidsДЎ-1/2' Omni R2 - WITH Strainer - 13' Length.

Ecr wires on sensus water meter